Crp Configuration; Enabling The Crp Application - AudioCodes Mediant 1000B User Manual

User's Manual
31

CRP Configuration

This section describes configuration specific to the CRP application. As CRP has similar
functionality to the SBC application, for configuration that is common to the SBC, which is
not covered in this section, see the following SBC sections:

''Configuring General Settings'' on page

''Configuring Admission Control'' on page

''Configuring Allowed Audio Coder Groups'' on page

''Configuring Classification Rules'' on page

''Configuring Message Condition Rules'' on page

''Configuring SBC IP-to-IP Routing Rules'' on page

''Configuring SIP Response Codes for Alternative Routing Reasons'' on page

''Configuring IP-to-IP Inbound Manipulations'' on page

''Configuring IP-to-IP Outbound Manipulations'' on page
Note:
applications is the navigation menu paths to opening these Web configuration pages.
Wherever "SBC" appears in the menu path, for the CRP application it appears as
"CRP".
31.1

Enabling the CRP Application

Before you can start configuring the CRP, you must first enable the CRP application. Once
enabled, the Web interface displays the menus and parameter fields relevant to the CRP
application.
Note:
License Key that includes this feature. For installing a Software License Key, see
''Software License Key'' on page 599.

To enable the CRP application:
1. Open the Applications Enabling page (Configuration tab > VoIP menu >
Applications Enabling > Applications Enabling).
2. From the 'CRP Application' drop-down list, select Enable.
3. Click Submit, and then reset the device with a burn-to-flash for your settings to take
effect.
Version 6.8
The main difference in the common configuration between the CRP and SBC
The CRP feature is available only if the device is installed with a Software
515
517
520
522
528
530
542
555 Mediant 1000B Gateway & SBC
31. CRP Configuration
538
545