Fxs Gateway Configuration - AudioCodes Mediant 1000B User Manual

Analog & digital voip media gateway enterprise session border controller gateway & e-sbc
Hide thumbs Also See for Mediant 1000B:
Table of Contents

Advertisement

User's Manual

27.14.5 FXS Gateway Configuration

The following procedure describes how to configure the FXS interface (at the 'remote PBX
extension').
To configure the FXS interface:
1.
In the Trunk Group table, assign the phone numbers 100 to 104 to the device's
endpoints.
Figure 27-11: Assigning Phone Numbers to FXS Endpoints
2.
In the Automatic Dialing page (see ''Configuring Automatic Dialing'' on page 462),
enter the phone numbers of the FXO device in the 'Destination Phone Number' fields.
When a phone connected to Port #1 off-hooks, the FXS device automatically dials the
number '200'.
3.
In the Outbound IP Routing table (see ''Configuring Outbound IP Routing Table'' on
page 383), enter 20 for the destination phone prefix, and 10.1.10.2 for the IP address
of the FXO device.
Note:
the FXS device (i.e., Enable Hold = 0) and hook-flash must be transferred from the
FXS to the FXO (HookFlashOption = 4).
Version 6.8
Figure 27-12: Automatic Dialing for FXS Ports
Figure 27-13: FXS Tel-to-IP Routing Configuration
For the transfer to function in remote PBX extensions, Hold must be disabled at
479
Mediant 1000B Gateway & SBC
27. Analog Gateway

Advertisement

Table of Contents
loading

Table of Contents