AudioCodes Mediant 1000B User Manual page 1001

User's Manual
Parameter
[AMDmode]
Energy Detector Parameters
Enable Energy Detector
CLI: energy-detector-enable
[EnableEnergyDetector]
Energy Detector Quality Factor
CLI: energy-detector-sensitivity
[EnergyDetectorQualityFactor]
Energy Detector Threshold
CLI: energy-detector-threshold
[EnergyDetectorThreshold]
Pattern Detection Parameters
Note: For an overview on the pattern detector feature for TDM tunneling, see DSP Pattern Detector
on page 344.
Web: Enable Pattern Detector
[EnablePatternDetector]
[PDPattern]
[PDThreshold]
Media Resource Control Protocol (MRCP) / Real Time Streaming Protocol (RTSP) Parameters
[MRCPDefaultMIMEType]
[MRCPEnabled]
Version 6.8
51. Configuration Parameters Reference
specific calls, using IP Profiles (IpProfile_AmdMode). For a
detailed description of this parameter and for configuring this
functionality in the IP Profile table, see Configuring IP
Profiles on page 302.
Note: If this functionality is configured for a specific IP
Profile, the settings of this global parameter is ignored for
calls associated with the IP Profile.
Enables the Energy Detector feature. This feature generates
events (notifications) when the signal received from the
PSTN is higher or lower than a user-defined threshold
(defined by the EnergyDetectorThreshold parameter).

[0] Disable (default)

[1] Enable
Defines the Energy Detector's sensitivity level.
The valid range is 0 to 10, where 0 is the lowest sensitivity
and 10 the highest sensitivity. The default is 4.
Defines the Energy Detector's threshold. A signal below or
above this threshold invokes an 'Above' or 'Below' event.
The threshold is calculated as follows:
Actual Threshold = -44 dBm + (EnergyDetectorThreshold *
6)
The valid value range is 0 to 7. The default is 3 (i.e., -26
dBm).
Enables the Pattern Detector (PD) feature.

[0] Disable (default)

[1] Enable
Defines the patterns that can be detected by the Pattern
Detector.
The valid range is 0 to 0xFF.
Note: For this parameter to take effect, a device reset is
required.
Defines the number of consecutive patterns to trigger the
pattern detection event.
The valid range is 0 to 31. The default is 5.
Note: For this parameter to take effect, a device reset is
required.
Determines the default format for speech recognition for
inline grammars.

[0] = (Default) Indicates GRXML

[1] = Indicates GL (Nuance format)
Activates the Media Resource Control Protocol (MRCP)
1001
Description
Mediant 1000B Gateway & SBC