Intrusion Detection System - AudioCodes Mediant 1000B User Manual

13.3

Intrusion Detection System

The device's Intrusion Detection System (IDS) feature detects malicious attacks on the
device and reacts accordingly. A remote host is considered malicious if it has reached or
exceeded a user-defined threshold (counter) of specified malicious attacks.
If malicious activity is detected, the device can do the following:

Block (blacklist) remote hosts (IP addresses / ports) considered by the device as
malicious. The device automatically blacklists the malicious source for a user-defined
period after which it is removed from the blacklist.

Send SNMP traps to notify of malicious activity and/or whether an attacker has been
added to or removed from the blacklist. For more information, see ''Viewing IDS
Alarms'' on page 155.
The Intrusion Detection System (IDS) is an important feature for Enterprises to ensure
legitimate calls are not being adversely affected by attacks and to prevent Theft of Service
and unauthorized access.
There are many types of malicious attacks, the most common being:

Denial of service: This can be Denial of Service (DoS) where an attacker wishing to
prevent a server from functioning correctly directs a large amount of requests –
sometimes meaningless and sometimes legitimate, or it can be Distributed Denial of
Service (DDoS) where the attacker controls a large group of systems to coordinate a
large scale DoS attack against a system:
•
Message payload tampering: Attacker may inject harmful content into a message,
e.g., by entering meaningless or wrong information, with the goal of exploiting a
buffer overflow at the target. Such messages can be used to probe for
vulnerabilities at the target.
•
Message flow tampering: This is a special case of DoS attacks. These attacks
disturb the ongoing communication between users. An attacker can then target
the connection by injecting fake signaling messages into the communication
channel (such as CANCEL messages).
•
Message Flooding: The most common DoS attack is where an attacker sends a
huge amount of messages (e.g., INVITEs) to a target. The goal is to overwhelm
the target's processing capabilities, thereby rendering the target inoperable.

SPAM over Internet Telephony (SPIT): VoIP spam is unwanted, automatically
dialed, pre-recorded phone calls using VoIP. It is similar to e-mail spam.

Theft of Service (ToS): Service theft can be exemplified by phreaking, which is a type
of hacking that steals service (i.e., free calls) from a service provider, or uses a service
while passing the cost to another person.
The IDS configuration is based on IDS Policies, where each policy can be configured with
a set of IDS rules. Each rule defines a type of malicious attack to detect and the number of
attacks during an interval (threshold) before an SNMP trap is sent. Each policy is then
applied to a target under attack (SIP interface) and/or source of attack (Proxy Set and/or
subnet address).
User's Manual
Mediant 1000B Gateway & SBC
148 Document #: LTRT-27034