AudioCodes Mediant 1000B User Manual page 815

User's Manual
Parameter
EMS: Packetization Period
CLI: packing-factor
[FaxModemBypassM]
CLI: fax-modem-telephony-
events-mode
[FaxModemNTEMode]
Web/EMS: Fax Bypass Payload
Type
CLI: fax-bypass-payload-type
[FaxBypassPayloadType]
EMS: Modem Bypass Payload
Type
CLI: modem-bypass-payload-
type
[ModemBypassPayloadType]
EMS: Relay Volume (dBm)
CLI: volume
[FaxModemRelayVolume]
Web/EMS: Fax Bypass Output
Gain
CLI: fax-bypass-output-gain
[FaxBypassOutputGain]
Web/EMS: Modem Bypass
Output Gain
[ModemBypassOutputGain]
EMS: Basic Packet Interval
CLI: modem-bypass-output-gain
[FaxModemBypassBasicRTP
PacketInterval]
EMS: Dynamic Jitter Buffer
Minimal Delay (dB)
CLI: jitter-buffer-minimum-delay
[FaxModemBypasDJBufMinD
elay]
Version 6.8
The valid range is 1, 2, or 3 coder payloads. The default is 1 coder
payload.
Determines whether the device sends RFC 2833 ANS/ANSam
events upon detection of fax and/or modem Answer tones (i.e.,
CED tone).

[0] = Disabled (default)

[1] = Enabled
Note: This parameter is applicable only when the fax or modem
transport type is set to bypass or Transparent-with-Events.
Defines the fax bypass RTP dynamic payload type.
The valid range is 96 to 120. The default is 102.
Defines the modem bypass dynamic payload type.
The range is 0-127. The default is 103.
Defines the fax gain control.
The range is -18 to -3, corresponding to -18 dBm to -3 dBm in 1-dB
steps. The default is -6 dBm fax gain control.
Defines the fax bypass output gain control.
The range is -31 to +31 dB, in 1-dB steps. The default is 0 (i.e., no
gain).
Defines the modem bypass output gain control.
The range is -31 dB to +31 dB, in 1-dB steps. The default is 0 (i.e.,
no gain).
Defines the basic frame size used during fax/modem bypass
sessions.

[0] = (Default) Determined internally

[1] = 5 msec (not recommended)

[2] = 10 msec

[3] = 20 msec
Note: When set to 5 msec (1), the maximum number of
simultaneous channels supported is 120.
Defines the Jitter Buffer delay (in milliseconds) during fax and
modem bypass session.
The range is 0 to 150 msec. The default is 40.
815
51. Configuration Parameters Reference
Description
Mediant 1000B Gateway & SBC