Debugging And Diagnostics Parameters; General Parameters - AudioCodes Mediant 1000B User Manual

Parameter
Web: End Time / Day of Month
End
EMS: End
CLI: end
[DayLightSavingTimeEnd]
Web/EMS: Offset
CLI: offset
[DayLightSavingTimeOffset]
51.3

Debugging and Diagnostics Parameters

This subsection describes the device's debugging and diagnostic parameters.

51.3.1 General Parameters

The general debugging and diagnostic parameters are described in the table below.
Table 51-19: General Debugging and Diagnostic Parameters
Parameter
EMS: Enable Diagnostics
[EnableDiagnostics]
Web: Enable LAN Watchdog
[EnableLanWatchDog]
User's Manual

hh denotes hour (e.g., 23)

mm denotes minutes (e.g., 10)
For example, "04:FRI/03:23:00" denotes Friday, the third week of
April, at 11 P.M. The week field can be 1-5, where 5 denotes the
last occurrence of the specified day in the specified month. For
example, "04:FRI/05:23:00" denotes the last Friday of April, at 11
P.M.
Defines the date and time when daylight saving ends. For a
description of the format of this value, see the
DayLightSavingTimeStart parameter.
Defines the daylight saving time offset (in minutes).
The valid range is 0 to 120. The default is 60.
Note: The offset setting is applied only on the hour. For example, if
you configure this parameter at 15:42, the device applies the setting
only at 16:00.
Determines the method for verifying correct functioning of the
different hardware components on the device. On completion of the
check and if the test fails, the device sends information on the test
results of each hardware component to the Syslog server.

[0] = (Default) Rapid and Enhanced self-test mode.

[1] = Detailed self-test mode (full test of DSPs, PCM, Switch,
LAN, PHY and Flash).

[2] = A quicker version of the Detailed self-test mode (full test of
DSPs, PCM, Switch, LAN, PHY, but partial test of Flash).
Note: For this parameter to take effect, a device reset is required.
Enables the LAN watchdog feature. The LAN watchdog detects
any logical network failure.

[0] Disable (default)

[1] Enable & Reset = Enables LAN watchdog. If the device
detects a network failure, the device resets.

[2] Enable & No Reset = Enables LAN watchdog. If the device
detects a network failure, it does not undergo a reset.
The LAN watchdog periodically checks the device's overall
communication integrity by pinging the network. If the device
detects a communication failure lasting longer than three minutes,
it performs a self-test:
738
Mediant 1000B Gateway & SBC
Description
Description
Document #: LTRT-27034