AudioCodes Mediant 1000B User Manual page 260

Parameter
TCP Port
CLI: tcp-port
[SIPInterface_TCPPort]
TLS Port
CLI: tls-port
[SIPInterface_TLSPort]
SRD
CLI: srd
[SIPInterface_SRD]
Message Policy
CLI: message-policy
[SIPInterface_MessagePolic
y]
TLS Context Name
CLI: tls-context-name
[SIPInterface_TLSContext]
TLS Mutual Authentication
CLI: tls-mutual-auth
[SIPInterface_TLSMutualAut
hentication]
User's Manual
Defines the listening TCP port.
The valid range is 1 to 65534. The default is 5060.
Notes:

This port must be outside of the RTP port range.

Each SIP Interface must have a unique signaling port (i.e., no two
SIP Interfaces can share the same port - no port overlapping).
Defines the listening TLS port.
The valid range is 1 to 65534. The default is 5061.
Notes:

This port must be outside of the RTP port range.

Each SIP Interface must have a unique signaling port (i.e., no two
SIP Interfaces can share the same port - no port overlapping).
Assigns an SRD ID to the SIP Interface (configured in ''Configuring
SRDs'' on page 256).
The default is 0.
Notes:

You can assign the same SRD ID to up to two SIP Interfaces of
the same application type.

For the SAS application, use only SRD ID 0.

Each SIP Interface of the same application type (e.g., SBC) that
is assigned to the same SRD must be configured with the same
IP version (IPv4 or IPv6).

All the SIP Interfaces that are assigned to the same SRD must
have the same network interface (assigned in the 'Network
Interface' parameter, above).
Assigns a SIP message policy to the SIP interface (configured in
''Configuring SIP Message Policy Rules'').
Assigns a TLS Context (SSL/TLS certificate) to the SIP Interface.
The TLS Context is assigned by name, as configured in the 'Name'
field of the TLS Contexts table.

Incoming calls: This TLS Context is used if no TLS Context is
configured for the Proxy Set associated with the call or
classification to an IP Group based on Proxy Set fails.

Outgoing calls: This TLS Context is used if no TLS Context is
configured for the Proxy Set associated with the call.
For more information about how certificates are associated with calls
and for configuring TLS Contexts, see Configuring SSL/TLS
Certificates on page 91.
Enables TLS mutual authentication for the SIP Interface.

[-1] Not Configured = (Default) The SIPSRequireClientCertificate
global parameter setting is applied.

[0] Disable = Device does not request the client certificate for TLS
connection on this SIP Interface.

[1] Enable = Device requires receipt and verification of the client
certificate to establish the TLS connection on this SIP Interface.
260
Mediant 1000B Gateway & SBC
Description
Document #: LTRT-27034