AudioCodes Mediant 1000B User Manual page 273

User's Manual
dialog as belonging to that IP Group. This feature is configured using the 'Classify by Proxy
Set' parameter in the IP Group table. For configuring IP Groups, see ''Configuring IP
Groups'' on page 261.
Note:
use ONLY the Classification table (see Configuring Classification Rules on page 522).
The following procedure describes how to configure Proxy Sets in the Web interface. You
can also configure Proxy Sets using the following management tools:

Proxy Set ID with IP addresses: table ini file parameter, ProxyIP or CLI command,
configure voip > voip-network proxy-ip > proxy-set-id

Attributes for the Proxy Set: table ini file parameter, ProxySet or CLI command,
configure voip > voip-network proxy-set

To configure a Proxy Set:
1. Open the Proxy Sets Table page (Configuration tab > VoIP menu > VoIP Network >
Proxy Sets Table).
2. Configure a Proxy Set according to the parameters described in the table below.
3. Click Submit, and then save ("burn") your settings to flash memory.
Version 6.8
For classifying incoming SIP dialogs to IP Groups, it is highly recommended to
Figure 17-6: Proxy Sets Table Page
273 Mediant 1000B Gateway & SBC
17. Control Network