AudioCodes Mediant 1000B User Manual page 432

inband, depending on the device's configuration). Typically, this Wink signal followed
by the DTMF digits initiates a call transfer.
For supporting the E911 service, used the following configuration parameter settings:

Enable911PSAP = 1 (also forces the EnableDIDWink and EnableReversalPolarity)

HookFlashOption = 1 (generates the SIP INFO hookflash message) or 4 for RFC 2833
telephony event

WinkTime = 700 (defines detection window of 50 to 750 msec for detection of both
winks - 250 msec wink sent by the PSAP for starting the device's dialing; 500 msec
wink during the call)

IsTwoStageDial = 0

EnableHold = 0

EnableTransfer = 0
•
Use RFC 2833 DTMF relay:
♦
♦
♦

TimeToSampleAnalogLineVoltage = 100

WaitForDialTime = 1000 (default is 1 sec)

SetDefaultLinePolarityState = 0 (you need to verify that the RJ-11 two-wire cable is
connected without crossing, Tip to Tip, Ring to Ring. Typically, the Tip line is positive
compared to the Ring line.)
Note: If the two-wire cable is crossed, the SetDefaultLinePolarityState parameter
must be set to 1.
The device expects to receive the ANI number in the From and/or P-Asserted-Identity SIP
header. If the pseudo-ANI number exists, it should be sent as the display name in these
headers.
Table 26-3: Dialed Number by Device Depending on Calling Number
Digits of Calling
Digits of Displayed Number
Number (ANI)
8
"nnnnnnnn"
12
"nnnnnnnnnnnn"
12
"nnnnnnnnnnnn"
2
"nn"
1
"n"
Table notes:

For all other cases, a SIP 484 response is sent.
User's Manual
RxDTMFOption = 3
TxDTMFOption = 4
RFC2833PayloadType = 101
-
None
10
"mmmmmmmmmm" (pANI)
None
-
Mediant 1000B Gateway & SBC
Number Dialed MF Digits
MF dialed "KPnnnnnnnnST"
"KPnnnnnnnnnnnnSTP"
"KPnnnnnnnnnnnnSTKPmmmmmmmmmmST"
MF dialed "KPnST"
For example:
"From: <sip:8>@xyz.com>" generates device
MF spill of KP 8 ST
432
"KPnnSTP"
Document #: LTRT-27034