AudioCodes Mediant 1000B User Manual page 314

Parameter
Web: Hold
CLI: enable-hold
[IpProfile_EnableHold]
Web: Add IE In Setup
CLI: add-ie-in-setup
[IpProfile_AddIEInSetup]
Web: AMD Sensitivity
Parameter Suite
CLI: amd-sensitivity-parameter-
suit
[IpProfile_AMDSensitivityParam
eterSuit]
User's Manual
Thus, it is always correct to include the 'telephony-event' parameter
by default in the SDP. However, some devices use the absence of
the 'telephony-event' in the SDP to decide to send DTMF digits in-
band using G.711 coder. If this is the case, set this parameter to 0.
Note: The corresponding global parameter is RxDTMFOption.
Enables the Call Hold feature (analog interfaces) and interworking
of the Hold/Retrieve supplementary service from ISDN PRI to SIP
(digital interfaces). The Call Hold feature allows users, connected
to the device, to place a call on hold (or remove from hold), using
the phone's Hook Flash button.

[0] Disable

[1] Enable (default)
Notes:

Digital interfaces: To interwork the Hold/Retrieve supplementary
service from SIP to ISDN (QSIG and Euro ISDN), set the
EnableHold2ISDN parameter to 1.

Analog interfaces: To use the call hold service, the devices at
both ends must support this option.

The corresponding global parameter is EnableHold.
Defines an optional Information Element (IE) data (in hex format)
which is added to ISDN Setup messages. For example, to add IE
'0x20,0x02,0x00,0xe1', enter the value "200200e1".
Notes:

This IE is sent from the Trunk Group that are defined by the
SendIEonTG parameter .

You can configure different IE data for Trunk Group by
configuring this parameter for different IP Profiles and then
assigning the required IP Profile ID in the Inbound Routing
table.

This feature is similar to that of the EnableISDNTunnelingIP2Tel
parameter. If both parameters are configured, the
EnableISDNTunnelingIP2Tel parameter takes precedence.

The corresponding global parameter is AddIEinSetup
Defines the AMD Parameter Suite to use for the Answering
Machine Detection (AMD) feature.

[0] 0 = (Default) Parameter Suite 0 based on North American
English with standard detection sensitivity resolution (8
sensitivity levels, from 0 to 7). This AMD Parameter Suite is
provided by the AMD Sensitivity file, which is shipped pre-
installed on the device.

[1] 1 = Parameter Suite 1 based on North American English
with high detection sensitivity resolution (16 sensitivity levels,
from 0 to 15). This AMD Parameter Suite is provided by the
AMD Sensitivity file, which is shipped pre-installed on the
device.

[2] 2 to [7] 7 = Optional Parameter Suites that you can create
based on any language (16 sensitivity levels, from 0 to 15). This
requires a customized AMD Sensitivity file that needs to be
installed on the device. For more information, contact your
AudioCodes sales representative.
Notes:

To configure the detection sensitivity level, use the 'AMD
314
Mediant 1000B Gateway & SBC
Description
Document #: LTRT-27034