AudioCodes Mediant 1000B User Manual page 668


To configure RADIUS accounting:
1. Open the RADIUS Parameters page (Configuration tab > VoIP menu > SIP
Definitions > RADIUS Parameters Settings).
2. Set the 'Enable RADIUS Access Control' parameter to Enable.
3. Configure the remaining parameters as required. For a description of these
parameters, see ''RADIUS Parameters'' on page 755.
4. Click Submit.
5. For your settings to take effect, reset the device with a flash burn.
The table below lists the RADIUS Accounting CDR attributes included in the
communication packets transmitted between the device and a RADIUS server.
Table 44-5: Supported RADIUS Accounting CDR Attributes
Attribute Attribute
Number Name
Request Attributes
1 user-name
4 nas-ip-
address
6 service-type
26 h323-
incoming-
conf-id
26 h323-remote-
address
26 h323-conf-id
26 h323-setup-
time
26 h323-call-
origin
26 h323-call-
type
User's Manual
Figure 44-3: RADIUS Accounting Parameters Page
Vendor
Specific
Purpose
Attribute
(VSA) No.
- Account number or
calling party number
or blank
- IP address of the
requesting device
- Type of service
requested
1 SIP call identifier
23 IP address of the
remote gateway
24 H.323/SIP call
identifier
25 Setup time in NTP
format 1
26 The call's originator:
Answering (IP) or
Originator (PSTN)
27 Protocol type or
family used on this
leg of the call
Mediant 1000B Gateway & SBC
Value
Format
String
up to 15
digits
long
Numeric 192.168.14.43
Numeric 1: login
Up to 32
octets
Numeric -
Up to 32
octets
String
String
String
668
Example AAA
5421385747 Start Acc
Stop Acc
Start Acc
Stop Acc
Start Acc
Stop Acc
- Start Acc
Stop Acc
Stop Acc
- Start Acc
Stop Acc
- Start Acc
Stop Acc
Answer, Start Acc
Originate etc Stop Acc
VoIP Start Acc
Stop Acc
Document #: LTRT-27034