AudioCodes Mediant 1000B User Manual page 970

Parameter
Web/EMS: Swap Redirect and
Called Numbers
CLI: swap-rdr-n-called-nb
[SwapRedirectNumber]
[UseReferredByForCallingNu
mber]
[SwapTel2IPCalled&Calling
Numbers]
Web/EMS: Add Prefix to
Redirect Number
CLI: add-pref-to-redir-nb
[Prefix2RedirectNumber]
Web: Add Number Plan and
Type to RPI Header
EMS: Add Ton 2 RPI
CLI: np-n-type-to-rpi-hdr
[AddTON2RPI]
Web/EMS: Source
Manipulation Mode
CLI: src-manipulation
[SourceManipulationMode]
User's Manual
remains.
Notes:

This parameter is applicable only if number manipulation is
performed after call routing for IP-to-Tel calls (i.e.,
RouteModeIP2Tel parameter is set to 0).

Similar operation (of removing the prefix) is also achieved by
using the usual number manipulation rules.

[0] No = (Default) Don't change numbers.

[1] Yes = Incoming ISDN call that includes a redirect number
(sometimes referred to as 'original called number') uses the
redirect number instead of the called number.
Determines whether the device uses the number from the URI in the
SIP Referred-By header as the calling number in the outgoing Q.931
Setup message, when SIP REFER messages are received.

[0] = (Default) No

[1] = Yes
Notes:

This parameter is applicable to all ISDN (TBCT, RLT, ECT) and
CAS blind call transfers (except for in-band) and when the device
receives SIP REFER messages with a Referred-By header.

This manipulation is done before regular IP-to-Tel source number
manipulation.
Determines whether the device swaps the calling and called
numbers received from the Tel side (for Tel-to-IP calls). The SIP
INVITE message contains the swapped numbers.

[0] = (Default) Disabled

[1] = Swap calling and called numbers
Note: This parameter can also be configured for a Tel Profile (in the
Tel Profile table).
Defines a string prefix that is added to the Redirect number received
from the Tel side. This prefix is added to the Redirect Number in the
SIP Diversion header.
The valid range is an 8-character string. By default, no value is
defined.
Determines whether the TON/PLAN parameters are included in the
Remote-Party-ID (RPID) header.

[0] No

[1] Yes (default)
If the Remote-Party-ID header is enabled (EnableRPIHeader = 1)
and AddTON2RPI = 1, it's possible to configure the calling and called
number type and number plan using the Number Manipulation tables
for Tel-to-IP calls.
Determines the SIP headers containing the source number after
manipulation:

[0] = (Default) The SIP From and P-Asserted-Identity headers
contain the source number after manipulation.

[1] = Only SIP From header contains the source number after
manipulation, while the P-Asserted-Identity header contains the
source number before manipulation.
970
Mediant 1000B Gateway & SBC
Description
Document #: LTRT-27034