Assigning Cost Groups To Routing Rules - AudioCodes Mediant 1000B User Manual

Parameter
[CostGroupTimebands_TimebandIndex]
Start Time
CLI: start-time
[CostGroupTimebands_StartTime]
End Time
CLI: end-time
[CostGroupTimebands_EndTime]
Connection Cost
CLI: connection-cost
[CostGroupTimebands_ConnectionCost]
Minute Cost
CLI: minute-cost
[CostGroupTimebands_MinuteCost]

15.4.2.4 Assigning Cost Groups to Routing Rules

To use your configured Cost Groups, you need to assign them to routing rules:

Gateway application: Outbound IP Routing table - see Configuring Outbound IP
Routing Table on page

SBC application: IP-to-IP Routing table - see Configuring SBC IP-to-IP Routing Rules
on page
User's Manual
index.
Defines the day and time of day from when this time
band is applicable. The format is DDD:hh:mm, where:


For example, SAT:22:00 denotes Saturday at 10 pm.
Defines the day and time of day until when this time
band is applicable. For a description of the valid values,
see the parameter above.
Defines the call connection cost during this time band.
This is added as a fixed charge to the call.
The valid value range is 0-65533. The default is 0.
Note: The entered value must be a whole number (i.e.,
not a decimal).
Defines the call cost per minute charge during this
timeband.
The valid value range is 0-65533. The default is 0.
Note: The entered value must be a whole number (i.e.,
not a decimal).
383
530
Mediant 1000B Gateway & SBC
Description
DDD is the day of the week, represented by the first
three letters of the day in upper case (i.e., SUN,
MON, TUE, WED, THU, FRI, or SAT).
hh and mm denote the time of day, where hh is the
hour (00-23) and mm the minutes (00-59)
232 Document #: LTRT-27034