AudioCodes Mediant 1000B User Manual page 779

User's Manual
Parameter
CLI: sip-tcp-local-port
[TCPLocalSIPPort]
Web: SIP TLS Local Port
EMS: TLS Local SIP Port
CLI: sip-tls-local-port
[TLSLocalSIPPort]
Web: Display Default SIP
Port
CLI: display-default-sip-port
[DisplayDefaultSIPPort]
Web/EMS: Enable SIPS
CLI: enable-sips
[EnableSIPS]
Web/EMS: Enable TCP
Connection Reuse
CLI: tcp-conn-reuse
[EnableTCPConnectionRe
use]
Web: Fake TCP alias
CLI: fake-tcp-alias
[FakeTCPalias]
Web/EMS: Reliable
Connection Persistent Mode
CLI: reliable-conn-persistent
Version 6.8
The valid range is 1 to 65535. The default is 5060.
Defines the local TLS port for SIP messages.
The valid range is 1 to 65535. The default is 5061.
Note: The value of this parameter must be different from the value of
the parameter TCPLocalSIPPort.
Enables the device to add the default SIP port 5060 (UDP/TCP) or
5061 (TLS) to outgoing messages that are received without a port.
This condition also applies to manipulated messages where the
resulting message has no port number. The device adds the default
port number to the following SIP headers: Request-Uri, To, From, P-
Asserted-Identity, P-Preferred-Identity, and P-Called-Party-ID. If the
message is received with a port number other than the default, for
example, 5070, the port number is not changed.
An example of a SIP From header with the default port is shown
below:
From:
<sip:+4000@10.8.4.105:5060;user=phone>;tag=f25419a
96a;epid=009FAB8F3E

[0] Disable (default)

[1] Enable
Enables secured SIP (SIPS URI) connections over multiple hops.

[0] Disable (default)

[1] Enable
When the SIPTransportType parameter is set to 2 (i.e., TLS) and the
parameter EnableSIPS is disabled, TLS is used for the next network
hop only. When the parameter SIPTransportType is set to 2 or 1 (i.e.,
TCP or TLS) and EnableSIPS is enabled, TLS is used through the
entire connection (over multiple hops).
Note: If this parameter is enabled and the parameter
SIPTransportType is set to 0 (i.e., UDP), the connection fails.
Enables the reuse of the same TCP connection for all calls to the
same destination.

[0] Disable = Uses a separate TCP connection for each call.

[1] Enable = (Default) Uses the same TCP connection for all calls.
Note: For the SAS application, this feature is configured using the
SASConnectionReuse parameter.
Enables the re-use of the same TCP/TLS connection for sessions with
the same user, even if the "alias" parameter is not present in the SIP
Via header of the first INVITE.

[0] Disable = (Default) TCP/TLS connection reuse is done only if
the "alias" parameter is present in the Via header of the first
INVITE.

[1] Enable
Note: To enable TCP/TLS connection re-use, set the
EnableTCPConnectionReuse parameter to 1.
Enables setting of all TCP/TLS connections as persistent and
therefore, not released.

[0] = (Default) Disable. All TCP connections (except those that are
779
51. Configuration Parameters Reference
Description
Mediant 1000B Gateway & SBC