Policy Route Settings - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
IPv6 Address/Prefix
Length
IPv6 Address
RIPng
OSPFv3
Hardware
Click the Find button to locate a specific entry based on the information entered.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

Policy Route Settings

This window is used to create a policy route and define the rule's name.
To view the following window, click L3 Features > Policy Route Settings, as shown below:
Figure 6-7 IPv6 Route Table window (EI Mode Only)
Figure 6-8 IPv6 Route Table window (SI Mode Only)
Description
Tick the check box and enter the IPv6 destination network address of the route.
Tick the check box and enter the IPv6 address.
Tick the check box to display the RIPng route entries. (EI Mode Only)
Tick the check box to display the OSPFv3 route entries. (EI Mode Only)
Tick the check box to display the route entries which have been written into
hardware table.
Figure 6-9 Policy Route Settings window
194