Dhcpv6 Relay Settings - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
DHCPv6 Relay State
DHCPv6 Relay Hops
Count (1-32)
Click the Apply button to accept the changes made for each individual section.

DHCPv6 Relay Settings

This window is used to configure the DHCPv6 relay state of one or all of the specified interfaces, and add or
display a destination IPv6 address to or from the switch's DHCPv6 relay table.
To view this window, click Network Application > DHCP > DHCPv6 Relay > DHCPv6 Relay Settings as shown
below:
The fields that can be configured are described below:
Parameter
Interface Name
DHCPv6 Relay State
DHCPv6 Server
Address
Click the Apply button to accept the changes made.
Click the Add button to add a new entry based on the information entered.
Click the Find button to locate a specific entry based on the information entered.
Click the View All button to display all the existing entries.
Figure 10-25 DHCPv6 Relay Global Settings window
Description
Click the radio buttons to enable or disable the DHCPv6 relay function.
Enter the number of relay agents that have to be relayed in this message. The default
value is 4.
Figure 10-26 DHCPv6 Relay Settings window
Description
Enter the name of the IPv6 interface. Tick the All check box to select all IPv6
interfaces.
Use the drop-down menu to enable or disable the DHCPv6 relay state of the interface.
Enter the DHCPv6 server IPv6 address.
486