D-Link xStack Reference Manual page 503

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
After clicking the Edit button, the following window appears:
The fields that can be configured are described below:
Parameter
MIP
SenderID
CCM
MEP ID(s)
Click the Apply button to accept the changes made.
After clicking the MIP Port Table button, the following page will appear:
Figure 11-3 CFM MA Settings (Edit) window
Description
This is the control creation of MIPs.
None - Don't create MIPs.
Auto - MIPs can always be created on any ports in this MA, if that port is not configured
with an MEP of that MA.
Explicit - MIP can be created on any ports in this MA, only if the next existent lower
level has an MEP configured on that port, and that port is not configured with an MEP
of this MA.
Defer - Inherit the setting configured for the maintenance domain that this MA is
associated with. This is the default value.
This is the control transmission of the sender ID TLV.
None - Don't transmit sender ID TLV.
Chassis - Transmit sender ID TLV with chassis ID information.
Manage - Transmit sender ID TLV with manage address information.
Chassis Manage - Transmit sender ID TLV with chassis ID information and manage
address information.
Defer - Inherit the setting configured for the maintenance domain that this MA is
associated with. This is the default value.
This is the CCM interval.
100ms - 100 milliseconds. Not recommended. For test purpose.
1sec - One second.
10sec - Ten seconds. This is the default value.
1min - One minute.
10min - Ten minutes.
This is to specify the MEP IDs contained in the maintenance association. The range of
the MEP ID is 1-8191.
Add - Add MEP ID(s).
Delete - Delete MEP ID(s).
By default, there is no MEP ID in a newly created maintenance association.
502