D-Link xStack Reference Manual page 255

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Query Interval (1-
31744)
State
Version
Max Response Time
(1-25)
Robustness Variable
(2-7)
Last Member Query
Interval (1-25)
Click the <<Back button to return to the previous window.
Click the Apply button to accept the changes made.
MLD Group Table
The window is used to display the MLD static groups on the Switch.
To view the following window, click L3 Features > IP Multicast Routing Protocol > MLD > MLD Group Table, as
shown below:
Figure 6-96 MLD Interface Settings –Edit window
Description
Enter a value between 1 and 31744 seconds, with a default of 125 seconds. This
specifies the interval between sending MLD queries.
Use the drop-down menu to enable or disable MLD for the IP interface. The default is
Disabled.
Use the drop-down menu to select the MLD version that will decide the interface to
send and process which version packets. By default, the version is 2.
Enter a value between 1 and 25 to specify the maximum amount of time allowed
before sending an MLD response report. The default time is 10 seconds.
A tuning variable to allow for subnetworks that are expected to lose a large number of
packets. A value between 2 and 7 can be entered, with larger values being specified
for subnetworks that are expected to lose larger numbers of packets. The default
setting is 2.
Enter a value between 1 and 25 to specify the maximum amount of time between
group-specific query messages, including those sent in response to leave group
messages. The default is 1 second.
Figure 6-97 MLD Group Table window
254