Ethernet Oam; Ethernet Oam Settings - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Click the Find button to locate a specific entry based on the information entered.

Ethernet OAM

Ethernet OAM Settings

This window is used to configure the Ethernet OAM settings.
To view this window, click OAM > Ethernet OAM > Ethernet OAM Settings, as shown below:
The fields that can be configured are described below:
Parameter
Unit
From Port / To Port
Mode
State
Remote Loopback
Figure 11-19 Ethernet OAM Settings window
Description
Select the switch unit to configure.
Select a range of ports you wish to configure.
Use the drop-down menu to select to operate in either Active or Passive. The default
mode is Active.
Use the drop-down menu to enable or disable the OAM function.
Use the drop-down menu to select Ethernet OAM remote loopback.
None – Select to disable the remote loopback.
Start – Select to request the peer to change to the remote loopback mode.
514