Ipv6 Route Table - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
IPv6 Address/Prefix
Length
IP Tunnel Name
Interface Name
Nexthop Address
Metric (1-65535)
Backup State
Click the Apply button to accept the changes made.
Click the Delete All button to remove all the entries listed.

IPv6 Route Table

This window is used to display the current IPv6 routing table.
To view the following window, click L3 Features > IPv6 Route Table, as shown below:
Figure 6-5 IPv6 Static/Default Route Settings window (EI Mode Only)
Figure 6-6 IPv6 Static/Default Route Settings window (SI Mode Only)
Description
Enter the destination network for the route, or tick the Default check box to be
assigned to the default route.
Tick the IP Tunnel check box and enter the IP tunnel name used. (EI Mode Only)
The IP Interface where the static IPv6 route is created.
The corresponding IPv6 address for the next hop Gateway address in IPv6 format.
The metric of the IPv6 interface entered into the table representing the number of
routers between the Switch and the IPv6 address above. Metric values allowed are
between 1 and 65535.
Each IPv6 address can only have one primary route, while another route should be
assigned to the backup state. When the primary route fails, the Switch will try the
backup route. The field represents the Backup for the IPv6 configuration. This field
may be Primary or Backup.
193