Igmp Snooping Static Group Settings - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter Description
Port List Enter the port list used for this configuration.
VID List
Enter the VID list used for this configuration.
Rate Limit (1- Enter the IGMP snooping rate limit used. By selecting the No Limit check box, the rate
1000) limit for the entered port(s) will be ignored.
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Edit button to re-configure the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

IGMP Snooping Static Group Settings

Users can view the Switch's IGMP Snooping Group Table. IGMP Snooping allows the Switch to read the Multicast
Group IP address and the corresponding MAC address from IGMP packets that pass through the Switch.
To view the following window, click L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping
Static Group Settings, as shown below:
The fields that can be configured are described below:
Parameter
VLAN Name
VID List
IPv4 Address
Click the Find button to locate a specific entry based on the information entered.
Click the Create button to add a new entry based on the information entered.
Click the Delete button to remove the specific entry based on the information entered.
Click the View All button to display all the existing entries.
Click the Edit button to re-configure the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Edit button, the following page will appear:
Figure 5-62 IGMP Snooping Static Group Settings window
Description
The VLAN Name of the multicast group.
The VID List or of the multicast group.
Enter the IPv4 multicast address.
140