D-Link xStack Reference Manual page 485

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Client DUID
Click the Add button to add a new entry based on the information entered.
Click the <<Back button to return to the previous window.
Click the Delete All button to remove all the entries listed.
Click the Delete button to remove the specific entry.
Click the Edit button under Pool to see the following window.
The fields that can be configured are described below:
Parameter
Begin Network
Address
End Network
Address
Network Address
Assigned Len
Interface Name
Domain Name
DNS Server
Preferred Lifetime
(60-4294967295)
Valid Lifetime (60-
4294967295)
Click the <<Back button to return to the previous window.
Click the Apply button to accept the changes made.
DHCPv6 Server Dynamic Binding
This window is used to show the DHCPv6 dynamic binding information.
To view this window, click Network Application > DHCP > DHCPv6 Server > DHCPv6 Server Dynamic Binding
as shown below:
Enter the DUID of the device to be statically bound to the IPv6 address entered in the
previous field.
Figure 10-22 DHCPv6 Server Pool Settings window
Description
Enter the beginning IPv6 network address of the DHCPv6 pool.
Enter the ending IPv6 network address of the DHCPv6 pool.
Enter the IPv6 network address of the DHCPv6 pool.
Enter the assigned length value here.
Enter the interface name used here.
The domain name is used by client when resolving hostnames with DNS.
Enter the DNS server IPv6 address for this pool. Users may specify up to two DNS
server addresses.
The amount of time (in seconds) that the IPv6 address, based on the specified pool,
remains in preferred state.
The amount of time (in seconds) that the IPv6 address, based on the specified pool,
remains in valid state.
484