Rip - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
To view the following window, click L3 Features > OSPF > OSPFv3 > OSPFv3 Neighbor Table, as shown below:
The fields that can be configured are described below:
Parameter
Interface Name
Neighbor IP Address
Click the Find button to find the specified entry.
Click the View All button to view all the entries.
OSPFv3 Virtual Neighbor Table
This window is used to display OSPFv3 virtual neighbor information.
To view the following window, click L3 Features > OSPF > OSPFv3 > OSPFv3 Virtual Neighbor Table, as shown
below:
The fields that can be configured are described below:
Parameter
Area ID
Neighbor ID
Click the Find button to find the specified entry.
Click the View All button to view all the entries.

RIP

The Routing Information Protocol is a distance-vector routing protocol. There are two types of network devices
running RIP - active and passive. Active devices advertise their routes to others through RIP messages, while
passive devices listen to these messages. Both active and passive routers update their routing tables based upon
RIP messages that active routers exchange. Only routers can run RIP in the active mode.
Every 30 seconds, a router running RIP broadcasts a routing update containing a set of pairs of network addresses
and a distance (represented by the number of hops or routers between the advertising router and the remote
Figure 6-80 OSPFv3 Neighbor Table window
Description
Enter the IP interface name where the neighbor is built.
Enter the router ID of the neighbor.
Figure 6-81 OSPFv3 Virtual Neighbor Table window
Description
Enter the transit area where the virtual neighbor is built.
Enter the router ID of the virtual neighbor.
242