Wac Global Settings - D-Link xStack Reference Manual

Xstack ds-3620 series web ui reference guide layer 3 managed stackable gigabit switch
Hide thumbs Also See for xStack:
Table of Contents

Advertisement

®
xStack
DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide

WAC Global Settings

Users can configure the Switch for the Web-based access control function.
To view this window, click Security > Web-based Access Control (WAC) > WAC Global Settings as shown
below:
The fields that can be configured are described below:
Parameter
WAC Global State
Virtual IP
Virtual IPv6
Redirection Path
Clear Redirection Path
RADIUS Authorization
Local Authorization
Method
HTTP(S) Port (1-65535)
Click the Apply button to accept the changes made for each individual section.
Figure 9-36 WAC Global Settings window
Description
Use this selection menu to either enable or disable the Web Authentication on the
Switch.
Enter a virtual IP address. This address is only used by WAC and is not known by
any other modules of the Switch.
Enter a virtual IPv6 address. This address is only used by WAC and is not known by
any other modules of the Switch.
Enter the URL of the website that authenticated users placed in the VLAN are
directed to once authenticated.
The user can enable or disable this option to clear the redirection path.
The user can enable or disable this option to enable RADIUS Authorization or not.
The user can enable or disable this option to enable Local Authorization or not.
Use this drop-down menu to choose the authenticator for Web-based Access
Control. The user may choose:
Local – Choose this parameter to use the local authentication method of the Switch
as the authenticating method for users trying to access the network via the switch.
This is, in fact, the username and password to access the Switch configured using
the WAC User Settings window seen below.
RADIUS – Choose this parameter to use a remote RADIUS server as the
authenticating method for users trying to access the network via the switch. This
RADIUS server must have already been pre-assigned by the administrator using the
Authentication RADIUS Server Settings window.
Enter a HTTP port number. Port 80 is the default.
HTTP – Specifies that the TCP port will run the WAC HTTP protocol. The default
value is 80. HTTP port cannot run at TCP port 443.
HTTPS – Specifies that the TCP port will run the WAC HTTPS protocol. The default
value is 443. HTTPS cannot run at TCP port 80.
414

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xstack dgs-3620-28sc

Table of Contents