D-Link xStack Reference Manual page 58

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Parameter
Interface Name
IPv6 State
Interface Admin State
IPv6 Network Address
Prefix Name
DHCPv6 Client PD
State
DHCPv6 Client PD
Prefix Name
DHCPv6 Client
NS Retransmit Time
(0-4294967295)
Automatic Link Local
Address
State
Life Time (0-9000)
Reachable Time (0-
3600000)
Retransmit Time (0-
4294967295)
Hop Limit (0-255)
Managed Flag
Other Configuration
Flag
Min Router AdvInterval
(3-1350)
Max Router AdvInterval
(4-1800)
Click the Apply button to accept the changes made for each individual section.
Click the <<Back button to discard the changes made and return to the previous page.
Click the View All IPv6 Address
Click the View Neighbor Discover
Description
Display the IPv6 interface name.
Use the drop-down menu to enable or disable IPv6 State.
Use the drop-down menu to enable or disable the Interface Admin State.
Enter the neighbor's global or local link address.
Enter the IPv6 prefix name used here.
Select to enable or disable the DHCPv6 client PD state of the interface.
Enter the DHCPv6 client PD prefix name used here.
Use the drop-down menu to enable or disable DHCPv6 client.
Enter the Neighbor solicitation's retransmit timer in millisecond here. It has the same
value as the RA retransmit time in the config ipv6 nd ra command. If this field is
configured, it will duplicate the entry into the RA field.
Use the drop-down menu to enable or disable the Automatic Link Local Address.
Use the drop-down menu to enable or disable router advertisement.
Enter the lifetime of the router between 0 and 9000 seconds as the default router.
Enter the amount of time that a node can consider a neighboring node reachable
after receiving a reachability confirmation, in milliseconds.
Enter the amount of time between retransmissions of router advertisement message
in millisecond, and the router advertisement packet will take it to host.
Enter the default value of the hop limit field in the IPv6 header for packets sent by
hosts that receive this RA message.
Use the drop-down menu to enable or disable the function. When Enabled, it
indicates that hosts receiving this RA must use a stateful address configuration
protocol to obtain an address, in addition to the addresses derived from the
stateless address configuration. Set to Disabled to stop hosts receiving the RA from
using a stateful address configuration to obtain an address.
Use the drop-down menu to enable or disable the function. When Enabled, it
indicates that hosts receiving this RA must use a stateful address configuration
protocol to obtain the address configuration information. Set to Disabled to stop
hosts receiving this RA from using a stateful address configuration protocol to obtain
the address configuration information.
Enter the minimum time allowed between sending unsolicited multicast Router
Advertisements from the interface, in seconds. It must be no less than 3 seconds
and no greater than .75 * MaxRtrAdvInterval. The default is 0.33 *
MaxRtrAdvInterval.
Enter the maximum time allowed between sending unsolicited multicast Router
Advertisements from the interface, in seconds. It must be no less than 4 seconds
and no greater than 1800 seconds. The default is 600 seconds.
link to view all the current IPv6 address.
link to view all IPv6 neighbor discover.
57