Ipv6 Static/Default Route Settings - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Network Address
IP Address
RIP
OSPF
Hardware
BGP
Click the Find button to locate a specific entry based on the information entered.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

IPv6 Static/Default Route Settings

A static entry of an IPv6 address can be entered into the Switch's routing table for IPv6 formatted addresses.
To view the following window, click L3 Features > IPv6 Static/Default Route Settings, as shown below:
Figure 6-3 IPv4 Route Table window (EI Mode Only)
Figure 6-4 IPv4 Route Table window (SI Mode Only)
Description
Enter the destination network address of the route want to be displayed.
Enter the destination IP address of the route want to be displayed. The longest prefix
matched route will be displayed.
Tick the check box to display only RIP routes.
Tick the check box to display only OSPF routes.
Tick the check box to display only the routes that have been written into the chip.
Tick the check box to display only BGP routes. (EI Mode Only)
192