Urpf Settings - D-Link xStack Reference Manual

Xstack ds-3620 series web ui reference guide layer 3 managed stackable gigabit switch

Hide thumbs Also See for xStack:

Table of Contents

DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide

Click the Find button to find the information entered.

Click the View All button to view all the entries.

URPF Settings

This window is used to configure the Unicast Reverse Path Forwarding (URPF) settings. This will add URPF

checking on one or more ports. URPF helps to mitigate problems caused by the introduction of malformed or

forged IP source addresses into a network by discarding IP packets that lack a verifiable IP source address.

To view the following window, click L3 Features > URPF Settings, as shown below:

The fields that can be configured are described below:

Select to enable or disable the URPF feature.

Select the switch unit to configure.

From Port ~ To

Select the range of port that will be used for this configuration.

Figure 6-182 URPF Settings window

Xstack dgs-3620-28sc