Igmp Multicast Group Profile Settings - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
1. Multicast VLANs can be implemented on edge and non-edge switches.
2. Member ports and source ports can be used in multiple Multicast VLANs. But member ports and source
ports cannot be the same port in a specific Multicast VLAN.
3. The Multicast VLAN is exclusive with normal 802.1q VLANs, which means that VLAN IDs (VIDs) and VLAN
Names of 802.1q VLANs and Multicast VLANs cannot be the same. Once a VID or VLAN Name is chosen
for any VLAN, it cannot be used for any other VLAN.
4. The normal display of configured VLANs will not display configured Multicast VLANs.
5. Once a Multicast VLAN is enabled, the corresponding IGMP/MLD snooping state of the VLAN will also be
enabled. Users cannot disable the IGMP/MLD feature for an enabled Multicast VLAN.
6. One IP multicast address cannot be added to multiple Multicast VLANs, yet multiple Ranges can be added
to one Multicast VLAN.

IGMP Multicast Group Profile Settings

Users can add a profile to which multicast address reports are to be received on specified ports on the Switch. This
function will therefore limit the number of reports received and the number of multicast groups configured on the
Switch. The user may set an IP Multicast address or range of IP Multicast addresses to accept reports (Permit) or
deny reports (Deny) coming into the specified switch ports.
To view the following window, click L2 Features > L2 Multicast Control > Multicast VLAN > IGMP Multicast
Group Profile Settings, as shown below:
The fields that can be configured are described below:
Parameter
Profile Name
Click the Add button to add a new entry based on the information entered.
Click the Find button to locate a specific entry based on the information entered.
Click the Delete All button to remove all the entries listed.
Click the View All button to display all the existing entries.
Click the Delete button to remove the corresponding entry.
Click the Group List link to configure the Multicast Group Profile Address Settings for the specific entry.
After clicking the Group List
Figure 5-84 IGMP Multicast Group Profile Settings window
Description
Enter a name for the IP Multicast Profile.
link, the following page will appear:
Figure 5-85 Multicast Group Profile Multicast Address Settings window
154