Ip Tunnel (Ei Mode Only); Ip Tunnel Settings - D-Link xStack Reference Manual

Xstack ds-3620 series web ui reference guide layer 3 managed stackable gigabit switch
Hide thumbs Also See for xStack:
Table of Contents

Advertisement

®
xStack
DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
as shown below:
The fields that can be configured are described below:
Parameter
Destination Protocol
Source Protocol
Type
Metric
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specified entry.
Click the Delete button to remove the specified entry.

IP Tunnel (EI Mode Only)

IP Tunnel Settings

This window is used to configure IP Tunnel Settings.
To view the following window, click L3 Features > IP Tunnel > IP Tunnel Settings, as shown below:
The fields that can be configured are described below:
Figure 6-21 IPv6 Route Redistribution Settings window
Description
Select the destination protocol used here. Options to choose from are RIPng and
OSPFv3.
Select the source protocol used here. Options to choose from are Local, Static, RIPng
and OSPFv3.
When OSPFv3 is select as the Destination Protocol, the following parameters will be
available for selection:
Type-1: Calculates the metric (for other routing protocols to OSPFv3) by adding the
destination's interface cost to the metric entered in the Metric field.
Type-2: Uses the metric entered in the Metric field without change. This field applies only
when the destination field is OSPFv3. If the metric type is not specified, it will be type 2.
Enter the metric value for this entry here.
Figure 6-22 IP Tunnel Settings window
202

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xstack dgs-3620-28sc

Table of Contents