Layer 2 Protocol Tunneling Settings; Spanning Tree - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide

Layer 2 Protocol Tunneling Settings

This window is used to configure the layer 2 Protocol tunneling port settings.
To view the following window, click L2 Features > Layer 2 Protocol Tunneling Settings, as shown below:
The fields that can be configured are described below:
Parameter
Layer 2 protocol
tunneling State
From Port / To Port
Type
Tunneled Protocol
Threshold (0-65535)
Click the Apply button to accept the changes made for each individual section.

Spanning Tree

This Switch supports three versions of the Spanning Tree Protocol: 802.1D-1998 STP, 802.1D-2004 Rapid STP,
and 802.1Q-2005 MSTP. 802.1D-1998 STP will be familiar to most networking professionals. However, since
802.1D-2004 RSTP and 802.1Q-2005 MSTP have been recently introduced to D-Link managed Ethernet switches,
a brief introduction to the technology is provided below followed by a description of how to set up 802.1D-1998 STP,
802.1D-2004 RSTP, and 802.1Q-2005 MSTP.
802.1Q-2005 MSTP
Figure 5-39 Layer 2 Protocol Tunneling Settings window
Description
Use the radio buttons to enable or disable the layer 2 protocol tunneling function
globally on the Switch.
Select a range of ports to use in the configuration.
Use the drop-down menu to select the type of the ports. Available choices are UNI, NNI
and None. The default type is None.
When UNI is selected in the Type drop-down menu, this drop-down menu shows the
following options:
STP- Specify the BPDU received on these UNI will be tunneled.
GVRP - Specify the GVRP PDU received on these UNI will be tunneled.
Protocol MAC - Specify the destination MAC address of the L2 protocol packets that will
tunneled on these UNI ports. At present, the MAC address can be 01-00-0C-CC-CC-CC
or 01-00-0C-CC-CC-CD.
All - Specify all supported.
Enter the drop threshold for packets-per-second accepted on this UNI port. The port
drops the PDU if the protocol's threshold is exceeded. The range of the threshold value
is 0 to 65535 (packet/second). The value 0 means unlimited. By default, the value is 0.
118