Bgp Trap Settings; Bgp Clear Settings - D-Link xStack Reference Manual
Xstack ds-3620 series web ui reference guide layer 3 managed stackable gigabit switch
Hide thumbs
Also See for xStack:
- Reference manual (1284 pages) ,
- User manual (357 pages) ,
- Hardware installation manual (71 pages)
Table of Contents
Advertisement
®
xStack
DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Mode
Regular Expression
Regular Option
Community Set
(1-65535)
Click the Apply button to accept the changes made.
Click the <<Back button to return to the previous window.
Click the Delete button to remove the specific entry.
BGP Trap Settings
This window is used to configure the BGP trap state.
To view the following window, click L3 Features > BGP > BGP Trap Settings, as shown below:
The fields that can be configured are described below:
Parameter
Peer Established
Trap State
Peer Idle Trap State
Click the Apply button to accept the changes made for each individual section.
BGP Clear Settings
This window is used to reset the Border Gateway Protocol (BGP) connections using hard or soft reconfigurations.
To view the following window, click L3 Features > BGP > BGP Clear Settings, as shown below:
Use the drop-down menu to permit or deny the routes if rule is matched.
Enter the community set value. This value can be up to 80 characters long.
Tick the check boxes to select the regular options.
Internet - Routes with this community will be sent to all peers either internal or external.
Local AS - Routes with this community will be sent to peers in the same AS, but will not
be sent to peers in another sub AS in the same confederation and to the external peers.
No Advertise - Routes with this community will not be advertised to any peer either
internal or external.
No Export - Routes with this community will be sent to peers in the same AS or in other
sub Autonomous Systems within a confederation, but will not be sent to an external BGP
(eBGP) peer.
A community is 4 bytes long, including the 2 bytes's for the Autonomous System's
number and 2 bytes for the network number This value is configured with two 2-byte
numbers separated by a colon. The valid range of both number are from 1 to 65535. A
community set can be formed by multiple communities, separated by a comma.
Figure 6-165 BGP Trap Settings window
Description
Enable or disable the sending of the peer established trap. The default value is
Disabled.
Enable or disable the sending of the peer idle trap. The default value is Disabled.
298
Advertisement
Table of Contents
