Snmp Global Settings; Snmp Traps Settings - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
uses the standard MIB-II Management Information Base module. Consequently, values for MIB objects can be
retrieved from any SNMP-based network management software. In addition to the standard MIB-II, the Switch also
supports its own proprietary enterprise MIB as an extended Management Information Base. Specifying the MIB
Object Identifier may also retrieve the proprietary MIB. MIB values can be either read-only or read-write.
The Switch incorporates a flexible SNMP management for the switching environment. SNMP management can be
customized to suit the needs of the networks and the preferences of the network administrator. Use the SNMP V3
menus to select the SNMP version used for specific tasks.
The Switch supports the Simple Network Management Protocol (SNMP) versions 1, 2c, and 3. The administrator
can specify the SNMP version used to monitor and control the Switch. The three versions of SNMP vary in the
level of security provided between the management station and the network device.
SNMP settings are configured using the menus located on the SNMP V3 folder of the Web manager. Workstations
on the network that are allowed SNMP privileged access to the Switch can be restricted with the Management
Station IP Address menu.

SNMP Global Settings

SNMP global state settings can be enabled or disabled.
To view the following window, click Management > SNMP Settings > SNMP Global Settings, as shown below:
The fields that can be configured are described below:
Parameter
SNMP State
SNMP UDP Port
Click the Apply button to accept the changes made.

SNMP Traps Settings

Users can enable and disable the SNMP trap support function of the switch and SNMP authentication failure trap
support, respectively.
To view the following window, click Management > SNMP Settings > SNMP Traps Settings, as shown below:
Figure 4-36 SNMP Global Settings window
Description
Enable this option to use the SNMP feature.
Enter the SNMP UDP port number.
72