Bgp Aggregate Address Settings; Bgp Network Settings - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide

BGP Aggregate Address Settings

This window is used to create an aggregate entry in the Border Gateway Protocol (BGP) database.
To view the following window, click L3 Features > BGP > BGP Aggregate Address Settings, as shown below:
The fields that can be configured are described below:
Parameter
IP Address
Netmask
Summary Only
AS Set
Click the Add button to add a new entry based on the information entered.
Click the Find button to locate a specific entry based on the information entered.
Click the Delete All button to remove all the entries listed.
Click the View All button to display all the existing entries.
Click the Delete button to remove the specific entry.

BGP Network Settings

This window is used to specify the network advertised by the Border Gateway Protocol (BGP).
To view the following window, click L3 Features > BGP > BGP Network Settings, as shown below:
The fields that can be configured are described below:
Parameter
IP Address
Figure 6-142 BGP Aggregate Address Settings window
Description
Enter the IP network address to be aggregated.
Enter the netmask of the IP network address to be aggregated.
Tick this check box to stop more specific routes from being advertised. The default
setting is un-ticked.
Tick this check box to generate Autonomous System set path information. The default
setting is un-ticked.
Figure 6-143 BGP Network Settings window
Description
Enter the IP address of the local network that BGP will advertise.
283