Japanese Web-Based Access Control (Jwac); Jwac Global Settings - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide

Japanese Web-based Access Control (JWAC)

JWAC Global Settings

This window is used to enable and configure Japanese Web-based Access Control on the Switch. JWAC and Web
Authentication are mutually exclusive functions. That is, they cannot be enabled at the same time. To use the
JWAC feature, computer users need to pass through two stages of authentication. The first stage is to do the
authentication with the quarantine server and the second stage is the authentication with the Switch. For the
second stage, the authentication is similar to Web Authentication, except that there is no port VLAN membership
change by JWAC after a host passes authentication. JWAC and WAC can share the same RADIUS server.
To view this window, click Security > Japanese Web-based Access Control (JWAC) > JWAC Global Settings
as shown below:
The fields that can be configured are described below:
Parameter
JWAC State
Virtual IP
IPv4 Virtual URL
UDP Filtering
Port Number (1-65535)
Figure 9-41 JWAC Global Settings window
Description
Click the radio buttons to enable or disable JWAC on the Switch.
Enter the JWAC Virtual IP address that is used to accept authentication requests
from an unauthenticated host. The Virtual IP address of JWAC is used to accept
authentication requests from an unauthenticated host. Only requests sent to this IP
will get a correct response.
NOTE: This IP does not respond to ARP requests or ICMP packets.
Enter the Virtual URL used.
Use the drop-down menu to enable or disable JWAC UDP Filtering. When UDP
Filtering is Enabled, all UDP and ICMP packets except DHCP and DNS packets from
unauthenticated hosts will be dropped.
Enter the TCP port that the JWAC Switch listens to and uses to finish the
authenticating process.
419