Download Firmware From Rcp - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
In the Download Firmware From TFTP section, the fields that can be configured are described below:
Parameter
Unit
TFTP Server IP
Source File
Destination File
Boot Up
Click Download to initiate the download.
In the TFTP Source IP Settings section, the fields that can be configured are described below:
Parameter
Interface Name
IPv4 Address
IPv6 Address
Click the Apply button to accept the changes made.
Click the Clear IP Address button to clear the IP addresses linked to the source IP interface.

Download Firmware from RCP

This window allows the user to download firmware from a RCP Server to the Switch and updates the switch.
Figure 13-5 Download Firmware from TFTP window
Description
Use the drop-down menu to select a unit for receiving the firmware. Select All for all
units.
Enter the TFTP server IP address used.
IPv4 Click the radio button to enter the TFTP server IP address used.
IPv6
Click the radio button to enter the TFTP server IPv6 address used.
Domain Name Click the radio button to enter the domain name.
Enter the location and name of the Source File.
Enter the location and name of the Destination File.
Tick the check box to set it as a boot up file.
Description
Enter the source interface name used here.
Enter the source IPv4 address used here.
Enter the source IPv6 address used here.
552