D-Link xStack Reference Manual page 589

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Parameters description:
unitID: The unit ID.
portNum: The port number.
thresholdType: the DDM threshold type. The value should be one of the
following values: temperature, supply voltage, bias current, TX power, RX
power.
exceedType: indicate exceed threshold or recover to normal event, the value
should be "recovered from" or "exceeded"
thesholdSubType: the DDM threshold sub type, the value should be "high" or
"low".
Event description: DDM exceeded or recover from DDM warning threshold
Log Message: DDM Port <[unitID:]portNum> optic module [thresholdType]
[exceedType] the [thresholdSubType] warning threshold
Parameters description:
unitID: The unit ID.
portNum: The port number.
thresholdType: the DDM threshold type. The value should be one of the
following values: temperature, supply voltage, bias current, TX power, RX
power.
exceedType: indicate exceed threshold or recover to normal event, the value
should be "recovered from" or "exceeded"
thesholdSubType: the DDM threshold sub type, the value should be "high" or
"low".
BPDU Attack Event description: BPDU attack happened.
Protection
Log Message: Port<[unitID:]portNum> enter BPDU under protection state
(mode: drop / block / shutdown)
Parameters description:
unitID: The unit ID.
portNum: The port number.
mode:The BPDU currnt state
Event description: BPDU attack automatically recover.
Log Message: Port <[unitID:]portNum> recover from BPDU under protection
state automatically
Parameters description:
unitID: The unit ID.
portNum: The port number.
Event description: BPDU attack manually recover.
Log Message: Port<[unitID:]portNum> recover from BPDU under protection
state manually.
Parameters description:
unitID: The unit ID.
portNum: The port number.
External Alarm Event description: External alarm occurred
Log Message: [Unit <unitID>] External Alarm Channel <channel_id> :
<alarm_message>
Parameters description:
unitID: The unit ID.
channel_id: Represent the channel ID detected the external alarm
alarm_message: Alarm message when alarm occurred, this is configurable
by user.
The default alarm message is defined in "Default Setting" Chapter.
RIPng Event description: The RIPng state of interface changed
Log Message: RIPng protocol on interface <intf-name> changed state to
<enabled | disabled>
Parameters description:
intf-name: Interface name.
LACP Event Description: Link Aggregation Group link change
Log Message: Link Aggregation Group <GROUP ID> (Interface: < ifIndex >)
<Link status>
Parameters Description:
Group ID: Link Aggregation Group ID
ifIndex: The interface index of the link aggregation group which link state was
link changed.
Link status: link status.
Value list:
Warning
Informational
Informational
Informational
Critical
Informational
Informational
588