Traffic Segmentation Settings - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Extensive NetBIOS
Filtering Ports
Ports
Click the Select All button to select all ports in each individual section.
Click the Clear All button to deselect all ports in each individual section.
Click the Apply button to accept the changes made for each individual section.

Traffic Segmentation Settings

Traffic segmentation is used to limit traffic flow from a single or group of ports, to a group of ports. This method of
segmenting the flow of traffic is similar to using VLANs to limit traffic, but is more restrictive. It provides a method of
directing traffic that does not increase the overhead of the master switch CPU.
To view this window, click Security > Traffic Segmentation Settings as shown below:
The fields that can be configured are described below:
Parameter
Port List
Forward Port List
Unit
Select the appropriate port to include in the Extensive NetBIOS filtering
configuration. Extensive NetBIOS is NetBIOS over 802.3. The Switch will deny the
NetBIOS over 802.3 frame on these enabled ports.
Tick the appropriate ports to be configured.
Figure 9-60 Traffic Segmentation Settings window
Description
Enter a port or list of ports to be included in the traffic segmentation setup. Tick the All
Ports check box to select all ports for the configuration.
Enter a port or list of ports to be included in the traffic segmentation setup. Tick the All
Ports check box to select all the ports for the configuration.
Select the switch unit to configure.
438