Ospf Lsdb Table - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Originate
Metric Type
Metric
Click the Apply button to accept the changes made.

OSPF LSDB Table

This window is used to display the OSPF Link State Database (LSDB).
To view the following window, click L3 Features > OSPF > OSPFv2 > OSPF LSDB Table, as shown below:
The fields that can be configured are described below:
Parameter
Area ID
Advertise Router ID
LSDB Type
Click the Find button to find the specified entry.
Click the View All button to view all the OSPF Link State Database entries.
Click the View Detail link to view the OSPF LSDB details of the specific entry.
After clicking the View Detail
Click the <<Back button to return to the previous window.
Description
Select the originate option here. Options to choose from are Always, Default, and None.
Select the metric type here. Options to choose from are:
Type-1: Calculates the metric (for other routing protocols to OSPF) by adding the
destination's interface cost to the metric entered in the Metric field.
Type-2: Uses the metric entered in the Metric field without change. This field applies only
when the destination field is OSPF. If the metric type is not specified, it will be type 2.
Enter the metric value here. This value must be between 1 and 65535.
Figure 6-52 OSPF LSDB Table window
Description
Enter a 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely
identifies the OSPF area in the OSPF domain.
Enter the router ID of the advertising router.
Use the drop-down menu to select the LSDB type to be displayed. Options to choose
from are None, RTRLink, NETLink, Summary, ASSummary, ASExtLink, NSSA Ext and
Stub.
link, the following window will appear.
Figure 6-53 OSPF LSDB Table - View Detail window
231