D-Link xStack Reference Manual page 271

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Group
Interface Name
Interface Name
Priority (0-255)
Interval (1-16383)
Click the Add button to add a new entry based on the information entered.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry.
PIM for IPv6 Static RP Settings
This window is used to create a static RP.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6 > PIM for
IPv6 Static RP Settings, as shown below:
The fields that can be configured are described below:
Parameter
Group
RP Address
Override Dynamic
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove the specific entry.
PIM for IPv6 Neighbor Table
This window is used to display the current PIM for IPv6 neighbor router table.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6 > PIM for
IPv6 Neighbor Table, as shown below:
Description
Enter the IPv6 group address range served by the RP.
Enter the interface that will act as the candidate RP.
Enter the RP IP interface used. Tick the All check box to select all RP IP interface.
Enter the RP priority value that will be used in the election process.
Enter the Candidate RP advertisement interval in seconds.
Figure 6-120 PIM for IPv6 Static RP Settings window
Description
Enter the multicast group network address for this static RP.
Enter the IPv6 address to this static RP.
Tick the check box so that the static RP will override any dynamically learned RP.
270