Ipv6 Static/Default Route Settings - D-Link xStack DGS-3400 Series User Manual

xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
The following fields can be set:
Parameter
IP Address
Subnet Mask
Gateway
Metric (1-65535)
Backup State
Click Apply to implement changes made.

IPv6 Static/Default Route Settings

A static entry of an IPv6 address can be entered into the Switch's routing table for IPv6 formatted addresses. To view the
following window, click Administration > Routing Table > IPv6 Static/Default Route Settings.
This window shows the following values:
Figure 6- 41. Static/Default Route Settings – Add window
Description
Allows the entry of an IP address that will be a static entry into the Switch's Routing Table.
Allows the entry of a subnet mask corresponding to the IP address above.
Allows the entry of an IP address of a gateway for the IP address above.
Allows the entry of a routing protocol metric representing the number of routers between
the Switch and the IP address above.
The user may choose between Primary and Backup. If the Primary Static/Default Route
fails, the Backup Route will support the entry. Please take note that the Primary and
Backup entries cannot have the same Gateway.
NOTE: Users must manually configure static ARP settings for hosts
connected to the Switch, because the Switch cannot automatically
learn host IP addresses.
Figure 6- 42. IPv6 Static Route Settings window
73