Save Trace; Set Trace Authentication - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
To clear the session manager trace, type the following command:
DWS-1008# clear trace sm
success: clear trace sm

save trace

Saves the accumulated trace data for enabled traces to a file in the switch's nonvolatile
storage.
Syntax: save trace filename
filename
Defaults: None.
Access: Enabled.
Examples: To save trace data into the file trace1 in the subdirectory traces, type the
DWS-1008# save trace traces/trace1

set trace authentication

Traces authentication information.
Syntax: set trace authentication [mac-addr mac-address] [port port-num] [user
username] [level level]
mac-addr mac-
address
port port-num
user username
level level
D-Link Systems, Inc.
Name for the trace file. To save the file in a
subdirectory, specify the subdirectory name, then a
slash. For example: traces/trace1
following command:
Traces a MAC address. Specify a MAC
address, using colons to separate the
octets (for example, 00:11:22:aa:bb:cc).
Traces a port number. Specify a switch
port number between 1 and 8.
Traces a user. Specify a username of up
to 32 alphanumeric characters with no
spaces.
Determines the quantity of information
included in the output. You can set the
level with an integer from 1 to 10, where
level 10 provides the most information.
Levels 1 through 5 provide user-readable
information. If you do not specify a level,
level 5 is the default.
Trace Commands
369