Trace Route - D-Link DGS-3630 Series Reference Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
Length
Stop Time
Click the Start button to initiate the Ping Test for each individual section.
After clicking the Start button in IPv4 Ping section, the following IPv4 Ping Result section will appear:
Click the Stop button to halt the Ping Test.
Click the Back button to return to the IPv4 Ping section.

Trace Route

The trace route page allows the user to trace a route between the Switch and a given host on the network.
To view the following window, click Tools > Trace Route, as shown below:
Description
Enter the length value here. This specifies the number of data bytes to send.
The default value is 56, which translates into 64 ICMPv6 data bytes when
combined with the 8 bytes of ICMPv6 header data. It does not include any
VLAN or IEEE 802.1Q tag length. The range is from 1 to 1420 bytes.
Enter the stop time value here. This specifies to stop the ping after the amount
of times entered here. If this value is configured as 0, then the ping can only be
stopped by clicking the Stop button manually. The range is from 0 to 99.
Figure 11-37 Ping (Start) Window
Figure 11-38 Trace Route Window
146