Show Arp - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide

show arp

Displays the ARP table.
Syntax: show arp [ip-addr]
ip-addr
Defaults: If you do not specify an IP address, the whole ARP table is displayed.
Access: All
Examples: The following command displays ARP entries:
DWS-1008# show arp
ARP aging time: 1200 seconds
Host
-------------
10.5.4.51
10.5.4.53
The table below describes the fields in this display.
Field
ARP aging time
Host
HW Address
VLAN
Type
State
D-Link Systems, Inc.
IP address.
HW Address VLAN Type
------------------------ -------- -------------
00:0b:0e:02:76:f5 1
00:0b:0e:02:76:f7 1
Number of seconds a dynamic entry can remain unused before
MSS removes the entry from the ARP table.
IP address, hostname, or alias.
MAC address mapped to the IP address, hostname, or alias.
VLAN the entry is for.
Entry type:
• DYNAMIC - Entry was learned from network traffic and
• LOCAL - Entry for the switch MAC address. Each VLAN
• PERMANENT - Entry does not age out and remains in
• STATIC - Entry does not age out but is removed after a
Entry state:
• RESOLVING - MSS sent an ARP request for the entry
• RESOLVED - Entry is resolved.
State
---------------
DYNAMIC RESOLVED
LOCAL RESOLVED
Description
ages out if unused for longer than the ARP aging
timeout.
has one local entry for the switch MAC address.
the configuration even following a reboot.
reboot.
and is waiting for the reply.
IP Services Commands
94