Show Arp - D-Link DGS-6600-48TS Manual

DGS-6604 m

show arp

show arp [ARP-MODE] [IP-ADDRESS [/ MASK]] [INTERFACE-ID]
Syntax Description
ARP-MODE
IP-ADDRESS
[/MASK]
INTERFACE-ID
Default
Command Mode
Usage Guideline
Example
Switch#show arp
Address
-------------------------------------------------------------------
10.108.42.112
10.108.42.114
10.108.42.121
Total Entries: 3
Switch#
CLI Reference Guide
Use the show arp command to display the Address Resolution Protocol (ARP)
cache.
(Optional) Displays the entries that are in a specific ARP mode. This argument
can be replaced by one of the following keywords:
dynamic—Displays only dynamic ARP entries. A dynamic ARP entry is learned
through an ARP request and completed with the MAC address of the external
host.
static—Displays only static ARP entries. A static ARP entry is a statically
configured (permanent) ARP.
(Optional) Displays the entries associated with a specific host or network entry
that is associated with an external host.
(Optional) Displays only the ARP table entries associated with this interface such
as, for example, a VLAN interface such as vlan100.
None
User EXEC mode or any configuration mode
ARP establishes correspondences between network addresses (an IP address,
for example) and LAN hardware addresses (Ethernet addresses). A dynamic
record of each correspondence is kept in a cache for a predetermined amount of
time and then discarded. The predetermined amount of time can be changed
using the arp timeout command. If no arp mode argument is specified, then all
of the arp entries are displayed.
The user can select to display a specific ARP entry, all ARP entries, dynamic
entries, static entries, or entries associated with an IP interface.
This example shows how to display the ARP cache. The field of IP Interface is
indicated with the Interface ID.
Hardware Addr
00-00-a7-10-4b-af
00-00-a7-10-85-9b
00-00-a7-10-68-cd
IP Interface
vlan100
vlan200
vlan300
show arp
Type
Static
Dynamic
Dynamic
578