Show Wireless Ports Interface Rf-Status - Extreme Networks ExtremeWare Command Reference Manual

Wireless Commands

show wireless ports interface rf-status

show wireless ports [<portlist> | all] interface [1 | 2] rf-status {detail}
Description
Displays data rates for the selected port and interface.
Syntax Description
portlist
all
interface
detail
Default
N/A.
Usage Guidelines
Each wireless port on the Alpine 3800 contains two interfaces. Interface 1 supports 802.11a, and interface
2 supports 802.11b/g radio signals. The
allows you to display information about one of the two individual interfaces (1|2) on a port or ports.
Examples
The following example displays rf-status of all active ports of the switch:
show wireless ports all interface 1 rf-status
The output of the command is similar to:
Port Intf Tx Rate
--------------------------------------------------------------
1:37 1 54
1:38 1 54
The following example displays detailed rf-status of all active ports of the switch:
show wireless ports all interface 1 rf-status detail
The output of the command is similar to:
Wireless Interface:
Transmit Rate:
Beacon Interval:
DTIM:
Preamble:
Long Retry:
Short Retry:
2098
Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
Specifies all active ports.
Specifies an interface: 1 or 2.
Specifies to display the information in detailed format.
show wireless port interface rf-status
Channel
64
64
1:37:1
54
40
2
Short
7
4
Noise Floor
85
84
ExtremeWare Software 7.3.0 Command Reference Guide
command