Starter Brush Inspection; Starter Field Winding; Starter Brush Holder Test - Honda S2000 Service Manual

!
\-
Starter Brush Inspection
11. lvleasure the brush length. lf it is not within the
service limit, replace the brush holder assembly.
Brush Length
Standard (New): 15.8 16.2 mm 10.62 0.64 in.)
Service Limit:
11.0 mm (0.43 in.)
Starter Field Winding Test
12. Check for continuity between the brushes (A). lf
there is no continuity, replace the armature
h o u s i n g ( B ) .
A
/ \
/ \ \
/
\ \
B
\ '
Check for continuity between each brush (A) and
the armature housing {B). lf there is continuity,
replace the armature housing.
1 5 .
Starter Brush Holder Test
14. Check that there is no continuity between the (+ )
b r u s h h o l d e r { A ) a n d ( ) b r u s h h o l d e r ( B ) . l f t h e r e
is continuity, replace the brush holder assembly.
Insert the brush (A) into the brush holder, and bring
the brush into contact with the commutator, then
attach a spring scale (B) to the spring (C). Measure
the spring tension at the moment the spring lifts off
t h e b r u s h .
Spring Tension:
15.7 17.7N (1.6 -1.8kgf.3.53 3.97 lbfl
(cont'd)
4-13