Default Ip Address And Default Gateway Configuration; Features Supported By The Sc0 And Sc1 In-Band Interfaces - Cisco WS-C6506 Software Manual

Default IP Address and Default Gateway Configuration

•
•
•
Default IP Address and Default Gateway Configuration
Table 3-2
Table 3-2
Feature
In-band (sc0) interface
In-band (sc1) interface
Default gateway address
SLIP
1. SLIP = Serial Line Internet Protocol

Features Supported by the sc0 and sc1 In-Band Interfaces

Table 3-3
Table 3-3
sc0 Interface
Downloading images
Ping
Telnet
SNMP
Default gateway support
BOOTP
DHCP
RARP
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
3-6
Standby and active supervisor engines must have the same file system. If the standby supervisor
engine has a different file system, it is moved into ROMMON with syslog and nvlog messages when
it becomes active.
The maximum capacity of the Melody Compact Flash memory card can be 1 GB.
Nonstandard memory cards and cards with varying read and write speeds are not supported.
shows the default IP address and default gateway configuration.
Switch IP Address and Default Gateway Default Configuration
1
(sl0) interface
lists the features that are supported by the sc0 and sc1 in-band interfaces.
Feature Support for sc0 and sc1 In-Band Interfaces
Chapter 3
Default Value
IP address, subnet mask, and broadcast address set to 0.0.0.0
•
Assigned to VLAN 1
•
IP address, subnet mask, and broadcast address set to 0.0.0.0
•
Assigned to VLAN 2
•
Set to 0.0.0.0 with a metric of 0
IP address and SLIP destination address set to 0.0.0.0
•
SLIP for the console port is not active (set to detach)
•
sc1 Interface
Downloading images
Ping
Telnet
SNMP
Default gateway support
—
—
—
Configuring the Switch IP Address and Default Gateway
OL-8978-04