Juniper JUNOS OS 10.3 - SOFTWARE Manual page 2937

Suboption Components of Option 82
Copyright © 2010, Juniper Networks, Inc.
address or another parameter for the client. See "Suboption Components of Option 82"
on page 2841 for details about option 82 information.
You can enable DHCP option 82 on a single VLAN or on all VLANs on the switch. You can
also configure it on Layer 3 interfaces (in routed VLAN interfaces, or RVIs) when the
switch is functioning as a relay agent.
When option 82 is enabled on the switch, then this sequence of events occurs when a
DHCP client sends a DHCP request:
The switch receives the request and inserts the option 82 information in the packet
1.
header.
The switch forwards or relays the request to the DHCP server.
2.
The server uses the DHCP option 82 information to formulate its reply and sends a
3.
response back to the switch. It does not alter the option 82 information.
The switch strips the option 82 information from the response packet.
4.
The switch forwards the response packet to the client.
5.
NOTE: To use the DHCP option 82 feature, you must ensure that the DHCP
server is configured to accept option 82. If it is not configured to accept
option 82, then when it receives requests containing option 82 information,
it does not use the information in setting parameters and it does not echo
the information in its response message. For detailed information about
configuring DHCP services, see the Junos OS System Basics Configuration
Guide at
http://www.juniper.net/techpubs/software/junos/index.html
configuration for DHCP service on the Juniper Networks EX Series Ethernet
Switch includes the
level.
Option 82 as implemented on the EX Series switch comprises the suboptions circuit ID,
remote ID, and vendor ID. These suboptions are fields in the packet header:
circuit ID—Identifies the circuit (interface and/or VLAN) on the switch on which the
request was received. The circuit ID contains the interface name and/or VLAN name,
with the two elements separated by a colon—for example,
is the interface name and
ge-0/0/10
received on a Layer 3 interface, the circuit ID is just the interface name—for example,
ge-0/0/10 .
Use the option to add an optional prefix to the circuit ID. If you enable the
prefix
option, the hostname for the switch is used as the prefix; for example,
switch1:ge-0/0/10:vlan1
You can also specify that the interface description be used rather than the interface
name and/or that the VLAN ID be used rather than the VLAN name.
dhcp statement at the
is the VLAN name. If the request packet is
vlan1
, where switch1 is the hostname.
Chapter 93: Port Security Overview
. The
[edit system services] hierarchy
, where
ge-0/0/10:vlan1
prefix
2841