CHAPTER 108
Examples: CoS Configuration
Example: Configuring CoS on EX Series Switches
Requirements
Overview and Topology
Copyright © 2010, Juniper Networks, Inc.
Example: Configuring CoS on EX Series Switches on page 3173
Example: Combining CoS with MPLS on EX Series Switches on page 3188
Configure class of service (CoS) on your switch to manage traffic so that when the
network experiences congestion and delay, critical applications are protected. Using CoS,
you can divide traffic on your switch into classes and provide various levels of throughput
and packet loss. This is especially important for traffic that is sensitive to jitter and delay,
such as voice traffic.
This example shows how to configure CoS on a single EX Series switch in the network.
Requirements on page 3173
Overview and Topology on page 3173
Configuration on page 3176
Verification on page 3186
This example uses the following hardware and software components:
Junos OS Release 9.0 or later for EX Series switches
One Juniper Networks EX3200 switch
This example uses the topology shown in Figure 81 on page 3174.
3173