Juniper JUNOS OS 10.3 - SOFTWARE Manual page 3187

Table 392: Supported Options for Firewall Filter Statements (continued)
Statement and Option
filter-specific
if-exceeding {
bandwidth-limit bps
burst-size-limit bytes
}
then {
policer-action
}
Copyright © 2010, Juniper Networks, Inc.
Junos OS for EX Series switches does not support some of the firewall filter statements
that are supported by other Junos OS packages. Table 393 on page 3092 shows the firewall
filter statements that are not supported by Junos OS for EX Series switches.
Chapter 105: Configuration Statements for Firewall Filters
Description
The statement configures policers and counters
filter-specific
for a specific filter name.
The option specifies the traffic rate in bits
bandwidth-limit bps
per second (bps).
You can specify as a decimal value or as a decimal number
bps
followed by one of the following abbreviations:
k (thousand)
m (million)
g (billion, which is also called a thousand million)
Range: 1000 (1k) through 102,300,000,000 (102.3g) bps
The option specifies the maximum
burst-size-limit bytes
allowed burst size to control the amount of traffic bursting. To
determine the value for the burst-size limit, you can multiply
the bandwidth of the interface on which the filter is applied by
the amount of time (in seconds) to allow a burst of traffic at
that bandwidth to occur:
burst size = bandwidth * allowable time for burst traffic
You can specify a decimal value or a decimal number followed
by k (thousand) or m (million).
Range: 1 through 2,147,450,880 bytes
Use the option to specify
policer-action
traffic that exceeds the rate limits.
to discard
discard
3091